Zhejiang HuaGong Eletric Co.,Ltd.

Products

Location \ HomeProductsExhibition Booth Floor Sockets BoxTDC-SW100

TDC-SW100 Series Exhibition Booth Floor Sockets Box

Features:

1.The socket box is seperated fully from the electric well bearing cover. 

2. The MCB,ELCB use the world famous brand,and are installed in the fully enclosed box that with sealing rubber gasket and buckles on the cover, effectively prevent dust and water etc entering, and to ensure the protection grade reaches IP65 above;

3.The industrial connector socket  use the world famous brand with high protection grade IP67, are installed on the outer side of the box and the direction is upward, to makes the pull out or plug in easier. 

4.The box body materials use 3mm #304 stainless steel , it has great rust and corrosion inhabit properties; 

5.The electric well bearing cover uses 10mm #304 stainless steel material, the load capacity is 50KN; 

6.The power inlet uses cable glands with high protection grade IP67, It has good tight seal performance. 

7.The box with their own mounting bracket to fit in the inwall of electric well, the distance between the electric well bearing cover and the top of box is 50-100mm, and  the distance between bottom of box and bottom of electric well is 200-300mm. Besides, there is a good drainage in the electric well, so that, though the water leak in to well it can still drain quickly, to make the box safe. 


Technical parameters:

Rated voltage:  AC220/380V
Rated insulationvoltage:  AC380V
Rated frequency:  50Hz
Rated current & short-time withstand current: main circuit 100A & 4.5KA
Protection grade: IP66
Load capacity of cover panel: 50KN
Output circuit: 6 circuits
Outlet of cover panel: 2 outlets
Rated current of output circuit: 380V/32A/IP67 for 2 circuit, 220V/16A/IP67 for 4 circuits
Outline size: 650(L)x650(W)x320(H)

Installation instruction:
1.Bar connector
2.Outlet
3.handle
4.Industrial connnector
5.10mm stainless steel cover
6.Buckle
7.Power cable gland
8.Power control box
9.5mm rubber gasket

Installation cautions:
1.The electric well frame should be made and constructed strictly according to the drawing;
2.The installed well frame should be symmetrical with the center of the electric well,The horizontal error must not be greater than 2mm;
3.The electric well should be fitted with a leak and a large diameter drainage pipe.

Mobile Website

Add:Shangmiao industrial area yueqing,zhejiang

Tel:86-0577-62796266

Fax:86-0577-62796366

Email:fggp@fggp.cc